The gasket of wind power flange is a kind of ring made of material which can produce plastic deformation and has certain strength. Most gaskets are cut from non-metallic plates, or made by professional factories according to the specified size, the materials are asbestos rubber board, asbestos board, polyethylene board, etc. There are also thin metal plates.
The material used for wind power flange is low-alloy high-strength steel Q345E/S355NL, the lowest temperature in the working environment is close to -40℃, and the maximum withstand wind force can reach grade 12. The requirement for heat treatment is normalizing, and the normalizing process can improve the comprehensive mechanical properties of forging flange by refining grain, uniform structure, and improving structure defects. Normalizing degree has a great influence on the microstructure, and the suitable temperature makes grain refinement, so as to obtain good performance. The temperature is too low, the effect is not big, the temperature is too high, the grain size is too big, easy to form the westerian structure, make the performance decline. The results show that the flange with better comprehensive mechanical properties can be obtained by adopting proper normalizing process.
General wind power has 65 meters, 70 meters, 85 meters, and more than 100 meters high. In order to facilitate transportation, the tower drum is usually divided into three sections for manufacturing and transportation. It is divided into three sections: top, middle and bottom. In the manufacturing process, flanges are used for connection of each section. Tower cylinder flanges have high requirements for welding deformation and generally require flanges to be turned inside out. Then they go to the construction site to be assembled.
A kind of pipe fitting which is bent by a complete set of bending die is widely used at present, and the following points should be paid attention to when it is used:1. In pure bending, the outer arm wall of the middle layer is thinned by tensile stress &1 under the action of external force distance M, while the inner side is compressed. As a result of the thickening, the combined forces of N1 and N2 changed the cross section of the pipe. Based on this factor, RX and SX are the main reasons for the quality decline of the elbow. Therefore, in gbj235-82, the RX value under various pressure levels and the outside thinning amount are clearly specified, in order to control the value of RX and SX, so as to ensure the quality. Tenon sealing surface, suitable for flammable, explosive, toxic medium and high pressure occasions. Flange pipe fitting with different properties has good product performance in different fields. It can produce different effects in different occasions and Spaces.
